IT cabinets are designed for installation of 19’’ standard active and passive telecommunication equipment in office and closed industrial locations.
The cabinet consists of: 2 supporting welded frames; base with fabrication holes for cable entry, which are normally closed with blanking plugs; perforated roof, holes for fans installation and fabrication holes for cable entry (which are normally closed with blanking plugs); side panels; front and rear doors.
Access for installation, commutation and equipment maintenance for wall mounted cabinets is possible from 3 sides: through side panels and front door. Access for installation, commutation and equipment maintenance for floor mounted cabinets is possible from 4 sides: through side panels, front and rear door. The cabinet could be completed with front glass or perforated door (fixing with twist lock door handle) and rear perforated or blank door (fixing with pin lock). In 6U, 9U, 12U cabinets with depth 450mm and 600mm one pair of vertical profiles with U label (marking counting is started from bottom to top) is installed. In 12U cabinets with depth 800mm, 18U, 24U, 42U four pairs of vertical profiles are placed. The installation depth of 19“vertical profiles could be varied depends on the distance between cleater angles and commutation point (optical patchcords, power cables and etc.), which are placed on the front part of the equipment. Fans could be installed into the 6U, 9U, 12U cabinet’s roof (Fans set for ShS 1pcs, 2 pcs, 4pcs). Fan panel could be installed into the 18U, 24U, 42U cabinet’s roof with frame fixation or four fans could be installed directly into the cabinets roof (center-to-center fixing is 105х105). Adjustable feet which are placed in cabinet base allow compensating floor unevenness. There is a possibility to complete set with castors (standard configuration doesn’t include this item).