Trust Us

8983-С Splicing Closure Kit and 8983-В-07 Pressure Blocking Kit
8983-C Splicing Closure Kit for pressurised and non-pressurised trunk cables with capacity from 1x4 up to 7x4.

8983-B-07 Pressure Blocking Kit for pressurised trunk cables with capacity from 1x4 up to 7x4.

Description

8983-C Splicing Closure Kits are used on pressurised and non-pressurised balanced trunk cables; suitable in protected and direct buried applications, and provide water resistance and mechanical protection of cable splices. The kits can be installed on cables with wide range of outer jackets type without interrupting air pressure.

Kit components

  1. Shield bond connectors.
  2. Shield conductor.
  3. U1B connectors.
  4. Al-PE tape.
  5. Closure body.
  6. VM mastic tape.
  7. Polyurhethane Armorcast tape.

Installation

  • preterminate cable according to instruction manual;
  • connect cable shield wires;
  • connect cable wires;
  • shield the splice by Al-PE tape;
  • put closure parts onto the splice;
  • wrap the splice with Armorcast and mastic tapes.

Maintenance

Mounted splice is ready for operation right after installation.

Note

The kit is available in different configuration by customer's order.

Order example

Two 7x4 trunk cables are to be spliced. These requirements are met by 8983-C-arm.

Description

8983-B Pressure Blocking Kits are used for blocking air leakage from trunk cable pot-head. The kit are suitable for installation in cable vaults, risers and manholes on horizontally mounted trunk cables.

Kit components

  1. Shield bond connectors.
  2. Shield conductor.
  3. 2900 mastic tape.
  4. DR tape.
  5. Spacer tape.
  6. 88T tape.
  7. Closure body.
  8. 4407 compound.

Installation

  • preterminate cable according to instruction manual;
  • connect shields of adjoint cable parts;
  • remove cable filler and strand fibers;
  • remove insulation in 5 mm on each wire in staggered order;
  • put closure parts onto the splice;
  • wrap the closure with mastic tapes;
  • fill the closure with compound.

Maintenance

Cable can be set under pressure in 24 hours after installation.

 

Note

The kits are available in two sizes:
8983-B-07 for 4x4 cables and 8984-B-07 for 7x4 cables.

 

Order example

Pressure blocking closure should be installed on 4x4 trunk cable. These requirements are met by 8983-B-07.
Support request

Support request