Trust Us

MMKR, MMKR(g) / ММКР, ММКР(г) Y-splices

for up to 5-pairs non-pressurised distribution cable lines

Description

Used for low-pair non-pressurised cable lines, and suitable as well as the indoor and outdoor, protected, direct buried and overhead applications

Kit components

MMKR Branching Kit contains:

  1. PE closure.
  2. Cable holder.
  3. clamp.
  4. UY2 connector.
  5. UR2 connector.
  6. 88T tape.
  7. Screening copper tape.
  8. 2900R mastic tape.
  9. 2229 mastic tape.

MMKR(g) Branching Kit contains:

  1. PE closure.
  2. Cable holder.
  3. Clamp.
  4. UY2 connector.
  5. UR2 connector.
  6. P3F spacer tape.
  7. Screening copper tape.
  8. 8882 High Gel.
  9. Plastic bag.
  10. Elastoseal.
  11. 2229 mastic tape.
  12. 88T tape.

Note

MMKR and MMKR(g) Branching Kits are used for branching up to five directions

Installation

  • put closure parts onto cables;
  • preterminate cable according to instruction manual;
  • fix the cable by holder;
  • connect cable wires;
  • reconstruct wrapping insulation;
  • shield splice by the shielding copper tape;
  • fill the splice by High Gel;
  • slide closure parts down to the splice;
  • seal joint between elements.

Maintenance

Mounted splice is ready for operation right after installation

Note

The kit is available in different configuration by customer's order

Order example

5-pair distribution cable installed in cable duct is to be branched to five directions with screening. These requirements are met by MMKR-5-1-ep

Support request

Support request