Trust Us

CCK(arm), BCCK(arm) Compression Splicing Kits

for non-pressurised telecommunication cables with capacity from 10 up to 600 pairs

Description

CCK(arm) Straight and BCCK(arm) Branching Compression Splicing Kits are specially designed for armoured cables. CCK(arm) and BCCK(arm) are used on non-pressurised distribution cable lines with capacity up to 600 pairs, suitable as well as the protected and direct buried applications, for both filled and dry cables, and provide water resistance and mechanical protection of cable splices. Cable splice is filled under pressure with 8882 High Gel and mechanically protected by polyurhethane Armorcast tape.

Kit components

  1. Polyurhethane Armorcast tape.
  2. Shield bond connectors.
  3. Shield conductor.
  4. Cable shield wire.
  5. UY2 connectors or MS2 modules.
  6. Р3Fspacer tape.
  7. Screening copper tape.
  8. 2900R mastic tape.
  9. Plastic bag, EZ vinyl tape.
  10. 8882 High Gel.

Installation

  • preterminate cable according to instruction manual;
  • connect cable shield wires;
  • connect cable wires;
  • reconstruct wrapping insulation by P3F tape;
  • shield the splice by the shielding copper tape;
  • wrap the splice with plastic bag;
  • fill the splice by High Gel;
  • tightly wrap the splice with EZ tape;
  • wrap the splice with Armorcast tape.

Maintenance

Mounted splice is ready for operation right after installation.

Note

The kit is available in different configuration by customer's order.

Order example

100-pair distribution armoured cable installed in cable-duct are to be branched with shielded distribution 50-pairs cable with screening. Cable wires should be connected by 25-pair modules. These requirements are met by BCCK 100(arm)-S25-ep.

 

<< back

Support request

Support request